www.malags.com
32
- Software upgrade. See Chapter 10.
- Restoration of predefined settings. See Below.
- Restoration factory Settings. See below.
Note! By pressing the next System settings screen is
reached.
By activating the kill-switch (mandatory under certain conditions, due to
FCC regulations, see FCC Part 15.509 stating that when working with the
high frequency antenna as a hand held and wall-scanning device, it is not
allowed to de-activate the kill-switch function, but when used as a normal
GPR, (floor scanning, shallow utility detection etc.) it’s allowed to de-
To Next Page
Loading...