11:00
Temperature detection check point
2(temperature slow down detection
check point)
1、Temperature at this point is end
of this round and start of next
round.
2、Per 10 minutes as a round, in
one round, detect the temperature
once every 5 minutes
3、At Temperature detection check
point 2, test method is the same
as Temperature detection check
point 1.(compare with
Temperature detection starting
check point)
Remarks
1、When the appliance stop heating, alarm 5s and fan
keep working 30s, then stand by, set temperature
mode light flickering and LED display OF and
flickering.
1.1Press to restart to the same working mode
before the appliance stop.
After restart, Open window detection start a new time
round.
1.2Press to turn off, then LED display Environment
temperature and the appliance stand by.
Week
timer
Week timer only can be start up when appliance in heating mode(can not start up
when appliance is only fan working) or in set temperature mode.
Present
time
First time
to start
up
First time to start up(start up after power cut off ), need to set
Present time.
Setting method:
a、Set day in one week: LED display 01, is Monday, press +
or - to adjust Present Day, 01-07, is from Monday to Sunday.
Press OK to finish setting.
b、Set hours: LED display 00, is 0H, press + or - to adjust
Present Hour, 00 to 23, is from 0H to 23H. Press OK to finish
setting.
c、Set minutes: LED display 00, is 0min,press + or - to adjust
Present Minute, 00 to 59, is from 0min to 59min. Press OK to
finish setting.
Note:
1、Not press OK within 10s after adjust, setting Present time
is failure.
2、Cut off power first then to reset Present time.
Present
time set
LED display P1
19/38
To Next Page
Loading...