Scirocco 2000 Page 3-1
3
Software features
Introduction
This chapter describes the features of the software which are specific to the disper-
sion unit. It covers:
Making a measurement – the basics of making a measurement using the dis-
persion unit.
Manually controlling the dispersion unit.
Writing an SOP for the dispersion unit.
Making a measurement
Making a measurement is fully documented in Chapter 4 of the main User Man-
ual. Refer to that manual for details.
The dispersion unit can either be controlled manually or automatically by running
a Standard Operating Procedure (SOP). The system automatically detects which
dispersion unit and cell is connected. If more than one dispersion unit is con-
nected, the system detects all dispersion units connected, but only the dispersion
unit that has its cell installed on the optical bench will be “active”.
MAN0386-1.0 Scirocco 2000.book Page 1 Friday, March 16, 2007 4:15 PM
To Next Page
Loading...
