Commissioning and operation
41
2nd step: Command takeover on the selected control stand.
Execution: – Press “Command” key once to take over the command
on this control stand.
Consequence: – The acoustic signal transmitter is silent.
– The “Command” display shows continuous light.
The command takeover is complete and the command is now at this control stand.
Free command change (without lever comparison)
With this variant, a control stand change takes place without taking account of the lever
position of the command master involved in the command change. The command
change takes place in one step.
Command takeover on the selected control stand
Execution: – Press “Command” key (white) to take over the command
on this control stand.
Consequence: – The “Command” display on the selected control stand
immediately shows continuous light.
The command is immediately at this control stand and the control system instantly runs
the lever position of the command master set here.
In this variant, carelessness can lead to manoeuvres that are not intended.
Example: Lever of the active command master is in position “Full forwards”.
Lever of the requesting command master is in the position “Full reverse”. If there
were a command change, a full reverse manoeuvre would be performed immedi-
ately.
To Next Page
Loading...
Need help?
General