Maintenance and care
55
Changing fuel filter
D Loosen filter cartridge by means of tape
wrench, unscrew it by hand and take it
off
D Moisten the seals on the new filter car-
tridge with fuel
D Screw on the filter cartridges and
tighten them vigorously by hand
D Bleed fuel system
D Check filter for leaks
Caution:
Used fuel filters are classed as
dangerous waste and must be dis-
posed of accordingly.
Bleeding the fuel system
Note:
To bleed the fuel system switch on
the “ignition” so that the EHAB will
be open.
An arrow on the filter head indicates the
direction of fuel flow.
D Unscrew bleed screw of first filter in di-
rection of flow by one or two turns
D Actuate tappet of hand primer until fuel
emerges without bubbles
D Screw in the tappet of the hand pump
again and tighten it
D Close bleed screw again
D Repeat this procedure at the second
bleed screw
D Check fuel system for leaks
To Next Page
Loading...
