Safety regulations
9
Risk of damage from penetration of dirt!
D When the clean side of the fuel system has been opened it is not permissible to use
compressed air for cleaning
D During assembly work loose dirt must be removed with the aid of suitable extractors
(industrial type vacuum cleaners)
D Use only fluffāfree cleaning cloths on the fuel system
D Clean tools and working materials before starting to work
D Only tools without any damage may be used (cracked chrome coatings)
D When removing and installing components do not use materials such as cloths,
cardboard or wood since these could shed particles and fine fibres
D If any paint chips/flakes off when connections are loosened (from possible overācoating)
these chippings must be carefully removed before finally loosening the screw
connection
D The connection openings of all parts removed from the clean side of the fuel system
must be immediately closed up with suitable caps/stoppers
D These caps/stoppers must be packed protected from dust prior to use and after being
used once they must be disposed of
D Following this all the components must be carefully stored in a clean, closed container
D Never use used cleaning or testing liquids for these components
D New parts must not be removed from their original packing material until directly before
use
D Work on removed components may be carried out only at a workplace specially
equipped for it
D If removed parts are shipped always use the original packing material of the new part
To Next Page
Loading...
