Manitou 100 SC-2 User Manual

3-15
AT THE PLATFORM CONTROLS
Test Emergency Stop
10- Push in the platform red Emergency Stop button to the off position.
> Result: The engine should shut off and no functions should operate.
11- Pull the red Emergency Stop button out to the on position.
> Result: The indicator light should be green.
Test the Horn
12- Push the horn button.
> Result: The horn should sound.
Test Up/Down Functions and Function Enable
13- Start the engine.
14- Activate the up/down rocker switch in the direction indicated by the blue arrow.
> Result: The platform should not raise.
15- Push and hold the lift function enable button.
16- Activate the up/down rocker switch in the direction indicated by the blue arrow.
> Result: The platform should raise.
17- Push and hold the lift function enable button.
18- Activate the up/down rocker switch in the direction indicated by the yellow arrow.
> Result: The platform should lower. The descent alarm should sound while the platform is lowering.
Test the Steering
Note: When performing the steer and drive function tests, stand in the platform facing the steer end of the machine.
19- Press and hold the function enable switch on the control handle.
20- Depress the thumb rocker switch on top of the control handle in the direction identified by the blue triangle on the control
panel.
> Result: The steer wheels should turn in the direction that the blue triangle points on the control panel.
21- Depress the thumb rocker switch in the direction identified by the yellow triangle on the control panel.
> Result: The steer wheels should turn in the direction that the yellow triangle points on the control panel.
Test Drive and Braking
22- Press and hold the function enable switch on the control handle.
23- Slowly move the control handle in the direction indicated by the blue arrow on the control panel until the machine begins to
move, then return the handle to the center position.
> Result: The machine should move in the direction that the blue arrow points on the control panel, then come to an abrupt
stop.
24- Press and hold the function enable switch on the control handle.
25- Slowly move the control handle in the direction indicated by the yellow arrow on the control panel until the machine begins to
move, then return the handle to the center position.
> Result: The machine should move in the direction that the yellow arrow points on the control panel, then come to an
abrupt stop.
Note: The brakes must be able to hold the machine on any slope it is able to climb.
647367 (01/03/2017) 100/120 SC-2 / 140 SC

Manitou 100 SC-2 Specifications

General

Brand	Manitou
Model	100 SC-2
Category	Lifting Systems
Language	English