Manitou MC 50 Turbo POWERSHIFT Serie 3-E3 - Page 139

3-31
C4 - PARKING BRAKE
CHECK - ADJUST
1MBDFUIFMJGUUSVDLPOBTMPQFMFTTUIBOXJUIUIFSBUFEMPBEJOUIFUSBOTQPSUQPTJUJPO
- Check the tightening adjustment by locking the parking brake in position A (fig. C4/1).
- The adjustment is correct when the lift truck is held stationary on a slope.
- Carry out adjustments if necessary.
"%+645*/(5)&1"3,*/(#3",&$"#-&0/5)&'30/5"9-&
- Press and release the brake pedal, then release the parking brake, putting it in position B (fig.
C4/1).
- Unscrew the nuts 1 (fig. C4/2).
- Adjust the cable by tightening or loosening the nuts 1 (fig. C4/2) to obtain a play of 1.5 mm
between the cams 2 (fig. C4/2) and the stops 3 (fig.
C4/2).
The manufacturer’s settings of the stops must never be changed.
"%+645*/(5)&1"3,*/(#3",&
- Leave the parking brake in position B (fig. C4/1).
- Progressively tighten the end piece of the lever 4 (fig.
C4/1) and recheck braking.
- Repeat the operation until the correct braking
adjustment is obtained.
C5 - CAB VENTILATION FILTER (OPTION AIR
CONDITIONING)
CHANGE
- Lift up protective casing 1 (fig. C5/1).
- Lift out cab ventilation filter 2 (fig. C5/2) and replace it with a new one (see:
3 - MAINTENANCE: FILTERS AND BELTS).
- Refit the protective casing.
C5/1
1
C5/2
2
C4/2
2
3
1
1
2
3
C4/1
4
A
B
647003 EN (03/01/2012)