Manitou MC 50 Turbo POWERSHIFT Serie 3-E3 - Page 153

3-45
E11 - REAR WHEEL REDUCER OIL
DRAIN
M 26-4 Turbo Série 3-E3 M 40-4 Turbo Série 3-E3
M 30-4 Turbo Série 3-E3 M 50-4 Turbo Série 3-E3
Place the lift truck on level ground with the I.C. engine stopped and the reducers oil still warm.
Dispose of the drain oil in an ecological manner.
- Drain and change the oil in each rear wheel reducer.
- Place drain plug 1 (fig. E11) in position A.
- Place a container under the drain plug and unscrew the plug.
- Let the oil drain fully.
- Place the drain port in position B, i.e. in a level port.
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by level port 1 (fig. E11).
- The level is correct when the oil level is flush with the edge of the hole.
- Refit and tighten the drain plug 1 (fig. E11) (tightening torque 34 to 49 N.m).
E11
1
A
B
647003 EN (03/01/2012)