Manitou MC 50 Turbo POWERSHIFT Serie 3-E3 - Page 159

3-51
LIFTING THE OVERHEAD GUARD OR CAB
Check that any object left in the operator’s stand cannot impede the operation.
- Slowly and slightly tilt the mast towards the front and release the support leg 5 (fig. G3/6).
- Continue lifting the overhead guard or the cab and insert the support leg in its end stops 6 (fig.
G3/7) at the earliest possible moment.
Do not raise the overhead guard or the cab more than necessary.
NOTE: The gear lever bellows will be turned inside out (according to model of lift truck).
- Slightly lower the overhead guard or cab to secure it in place (fig. G3/8).
LOWERING THE OVERHEAD GUARD OR CAB
- Tilt the mast forward slightly to release the support leg
and return it to its clip.
- Slowly lower the overhead guard or cab and check that
nothing impedes the operation
- Reinsert and tighten the silentblock fastening screws.
- Refit the side panels.
- Restore the gear box lever bellows to its correct shape
(according to the model of lift truck).
- Remove the cable, the eyes and refit the two screws on
the roof.
G4 - FRONT HEADLAMPS
ADJUST
RECOMMENDED SETTING
(as per standard ECE-76/756 76/761 ECE20)
4FU UP   PG UIF EJQQFE CFBN JO SFMBUJPO UP UIF IPSJ[POUBM MJOF
of the headlamp.
ADJUSTING PROCEDURE
- Place the lift truck unloaded and in the transport position
and perpendicular to a white wall on flat, level ground (fig. G4).
- Check the tyre pressures (see: 2 - DESCRIPTION: CHARACTERISTICS).
- Put the gear reverser lever in neutral and release the parking brake.
CALCULATING THE HEIGHT OF THE DIPPED BEAM (H2)
tI  )FJHIU PG UIF EJQQFE CFBN JO SFMBUJPO UP UIF
ground.
tI )FJHIUPGUIFBEKVTUFECFBN
tM%JTUBODFCFUXFFOUIFEJQQFECFBNBOEUIFXIJUFXBMM
G3/6
5
G3/7
6
6
h1
+%
-%
l
h1
h2
-2%
h2 = h1 - (l x 2 / 100)
G4
G3/8
647003 EN (03/01/2012)