1 - 25
GENERAL INSTRUCTIONS
- Ensure the area is sufficiently ventilated before starting the telehandler�
- Wear clothes suitable for the maintenance of the telehandler, avoid wearing jewellery and loose clothes� Tie and protect
your hair, if necessary�
- Stop the engine before carrying out any maintenance on the telehandler and remove the ignition key�
- Read the operator's manual carefully�
- Carry out all repairs immediately, even if the repairs concerned are minor�
- Repair all leaks immediately, even if the leak concerned is minor�
- Make sure that the disposal of process materials and of spare parts is carried out in total safety and in a ecological way�
- Be careful of the risk of burning and splashing (exhaust, radiator, engine, etc�)�
PLACING THE BOOM SAFETY WEDGE
- The telehandler is equipped with a boom safety wedge (e 2 - DESCRIPTION: INSTRUMENTS AND CONTROLS) that must
be installed on the rod of the lifting cylinder when working beneath the boom�
FITTING THE WEDGE
- Fully raise the boom�
- Place the safety wedge 1 on the rod of the lifting cylinder and secure with the rod
2and the pin 3�
- Slowly lower the boom then stop the hydraulic movements before it comes into
contact with the wedge�
REMOVING THE WEDGE
- Fully raise the boom�
- Remove the pin and the rod�
- Return the safety wedge to the storage location provided on the telehandler�
p
Only use the wedge supplied with the telehandler.
MAINTENANCE
- Perform the periodic service (e 3 - MAINTENANCE) to keep your telehandler in
good working condition� Failure to perform the periodic service may cancel the
contractual guarantee�
MAINTENANCE LOG
- The maintenance operations carried out in accordance with the recommendations
given in part: 3 - MAINTENANCE and the other inspection, maintenance or repair
operations or modifications performed on the telehandler or its attachments shall
be recorded in a maintenance logbook� The entry for each operation shall include
details of the date of the works, the names of the individuals or companies having
performed them, the type of operation and its frequency, if applicable� The part
numbers of any telehandler items replaced shall also be indicated�
1
3
3
2
2
To Next Page
Loading...
