Manitou MLT625-75 H S1-E3 - Page 99

3-133-13
- Check the condition of the tyres, to detect cuts, pr- Check the condition of the tyres, to detect cuts, protuberances, wear, etc.otuberances, wear, etc.
-- Check the torque load of the wheel nuts. Non compliance witCheck the torque load of the wheel nuts. Non compliance with this instruction can cause damage and rupture to the wheel boltsh this instruction can cause damage and rupture to the wheel bolts
and distortion to the wheels.and distortion to the wheels.
Wheel nuts tightening torqueWheel nuts tightening torque
• Fron• Front tyrest tyres: 630: 630 N.mN.m(465 lbf/ft)(465 lbf/ft)± 15%± 15%
• Rea• Rear tyrer tyres: 630s: 630 N.mN.m
(465 lbf/ft)(465 lbf/ft)
± 15%± 15%
- Check and adjust the tyre pr- Check and adjust the tyre pressures if necessary essures if necessary (see: 2 - DESCRIPTION: FRONT AND REAR TYRES).(see: 2 - DESCRIPTION: FRONT AND REAR TYRES).
Check that the air hose is correctly connected to the tyre valve before inflating and keep all persons at a distance during inflation. Respect theCheck that the air hose is correctly connected to the tyre valve before inflating and keep all persons at a distance during inflation. Respect the
recommended tyre pressures given.recommended tyre pressures given.
NOTE: There is an OPTIONAL wheel toolkit.NOTE: There is an OPTIONAL wheel toolkit.
A6 - JIB PADSA6 - JIB PADS
CLEAN - GREASECLEAN - GREASE
To be carried out every 10 hours during the first 50 hours service, then once at 250To be carried out every 10 hours during the first 50 hours service, then once at 250
hours.hours.
- Extend the - Extend the jib completely.jib completely.
-- With a brush, apply a coat With a brush, apply a coat of grease (see: 3 - MAINTENANCE: LUBRICof grease (see: 3 - MAINTENANCE: LUBRICANTS AND FANTS AND FUEL) onUEL) on
the 4 sides of the telescope(s) (fig. A6).the 4 sides of the telescope(s) (fig. A6).
-- TelTelescope the jib several times in order to spread the coat of grease evenlyescope the jib several times in order to spread the coat of grease evenly..
- Remove the surplus of grease.- Remove the surplus of grease.
If the lift truck is If the lift truck is used in an abrasive environment (dust, sand, coal…) Use lubricating varnish (MANITOUused in an abrasive environment (dust, sand, coal…) Use lubricating varnish (MANITOU
reference: 483536). In this rreference: 483536). In this respect, consult your dealer.espect, consult your dealer.
A6A6

https://www.forkliftpdfmanuals.com/