Manitou MT 1840 R PRIVILEGE - Page 59

2-28
YY
LOCKING SCREEN
By default, the operator is not permitted to unlock the functions
(see: 2 - DESCRIPTION: 6D - SCREEN DISPLAY: CONFIGURATION
SCREEN: 4 > ADMIN: 4.3).
One of these screens appears when the system detects an operating
defect on the lift truck, when this screen appears it makes a beeping
sound.
These defects cause certain functions to be prohibited in order to
ensure safety. However it is possible for the operator and under
his own responsibility (and/or that of the person in charge of the
establishment) to override the prohibition in order to secure the
parking of the lift truck (e.g., unlocking the hydraulic distributor fault
in order to retract and lower the jib).
The unlocking is activated temporarily, the function will be locked again as soon as the engine is switched off.
UNLOCKING THE FUNCTION
- Move the triangles using the scroll button on the open padlock and validate with the button .
- The button
allows you to leave this screen whilst keeping the function locked.
In any event, stop the lift truck and contact your dealer.
i
i
HELP SCREEN
One of these screens appears to inform the operator about the
operations to be carried out in the configuration for that time (e.g.,
if the operator wants to lower the stabilizers, first he must retract
and/or lower the jib), when this screen appears it makes a beeping
sound.
X
SELECTION SCREEN
These selection screens are visible at the time of selecting one of the following buttons:
ATTACHMENT CIRCUIT
See: 2 - DESCRIPTION: 6C - PANEL FOR BUTTONS AND KEYBOARD.
X
TRANSMISSION MODE
See: 2 - DESCRIPTION: 6C - PANEL FOR BUTTONS AND KEYBOARD.
YY
Driver presence.
YY
Transmission fault.
YY
Retracting stabilizer.
YY
Tilt.
YY
Telescoping jib.
YY
!
Hydraulic distributor.
!
i
i
Major maintenance interval exceeded.
i
i
Retract the stabilizers.
i
i
Retract and/or lower the jib before lowering
the stabilizers.
i
i
Driver presence not validated, close the door
and press the accelerator pedal.
i
i
Driver presence not validated, press the
accelerator pedal.
i
i
Overspeed. The visual alarm is triggered
at the same time. Immediately stop the lift
truck and find the cause.
i
i
Retract the jib before raising up the
stabilizers.
i
i
Raise the stabilizers and/or lower the jib
before correcting the tilt.
i
i
Retract and/or lower the jib in order to use the
jib suspension OPTION.
i
i
Lower the stabilizers before raising and/or
telescoping the jib.
XX%
i
i
Using the attachment circuit in continuous
mode and indicating the hydraulic capacity.
>> SET
NEUTRAL <<
i
i
Reset the forward/reverse selector via
neutral.