Manitowoc Grove RT9130E - Page 24

THIS CHART IS ONLY A GUIDE AND SHOULD NOT BE USED TO OPERATE THE CRANE.
The individual crane’s load chart, operating instructions and other instructional plates must be read and understood prior to operating the crane.
24
Load chart
On outriggers fully extended- 360°
Radius in feet 
Main boom length  ft*
10 48,000
12 48,000
15 48,000
20 48,000
25 48,000
30 48,000
Installation and removal of counterweight and auxiliary hoist rated lifting capacities in pounds
On rubber (stationary) - 360°
Radius in feet 
Main boom length  ft*
10 11,600
12 11,600
15 11,600
20 11,600
Installation and removal of front and rear outrigger boxes rated lifting capacities in pounds without counterweight
* The boom must be fully retracted.
Notes for on rubber
• CapacitiesareapplicabletomachinesequippedwithTitan33.25x29(38ply)tiresat85psicoldinflationpressure
Capacities do not exceed 75% of tipping loads as determined by test in accordance with SAE J765.
• Withnoload,theboomanglemustnotbelessthan35˚whenoversidesofmachinesincelossofstabilitywilloccur
causingatippingcondition.Tolowerboombelow35˚boomangle,boommustbeswungoverfrontorrearandLMI
bypass activated.
• Onceoneoutriggerboxisinstalled,donotswingloadoverthatendofthemachinewhileinstallingtheotheroutrigger
box.
• Eachoutriggerboxassemblyweighs9373lbincludingtheoutriggerbeamsandpads.
• Maybeusedforsingleordoublelineliftingservice.