Section 2 Installation Instructions
Part Number 000002477 3/08 2-31
Electronic Bin Thermostat Instructions
IB600C/IB800C/IB1000C Only
POSITIONING
1. Remove water trough.
2. Refer to illustration:
A. Loosen rear screw.
B. Remove front screw & rotate probe/bracket.
C. Re-install front screw & tighten.
D. Tighten rear screw.
Bin Thermostat Location
3. Re-install water trough.
4. Remove slack from sensor probe wire and verify
wire does not contact or obstruct the water curtain.
Control Location
5. The control is preset and does not require
programming
FINAL
POSITION
A. LOOSEN
REAR SCREW
B. REMOVE FRONT
SCREW & ROTATE
PROBE/BRACKET.
REINSTALL SCREW
To Next Page
Loading...
Need help?
General