Part Number 000014797 Rev02 05/18 43
BIN REMOVAL
U140/U190/U240/U310
1. Disconnect power.
2. Remove all ice from bin.
3. Remove air filter and louver from lower front of
machine.
4. Loosen screws and rotate clips to release bin from
base.
5. Disconnect clamp and remove bin drain.
6. Remove control box panel.
7. Remove communication cable from control board.
8. Remove rear cover.
9. Slide bin forward to remove.
NOTE: When reinstalling the bin, ensure the bin seal
is in place and is not pinched/folded as it mates to the
cabinet. A watertight seal is required to prevent future
condensation or water leakage from entering the ice
machine base.
DISCONNECT COMMUNICATION
CABLE
DISCONNECT CLAMP
AND REMOVE BIN DRAIN
SCREWS AND PLATES
To Next Page
Loading...
Need help?
General