To Next Page

To Previous Page

60 Part Number 000014797 Rev02 05/18

Step 7 Mix a solution of cleaner and warm water.

Depending on the amount of mineral buildup, a larger

quantity of solution may be required. Use the ratio in the

table below to mix enough solution to thoroughly clean

all parts.

Solution Type Water Mixed with

Cleaner 1 gal. (4 l) 16 oz (500 ml) cleaner

Step 8 Use ½ of the cleaner/water solution to clean

all components. The cleaner solution will foam when it

contacts lime scale and mineral deposits; once the foaming

stops use a soft bristle brush, sponge or cloth (not a wire

brush) to carefully clean the parts. Soak the parts for 5

minutes (15 – 20 minutes for heavily scaled parts). Rinse all

components with clean water.

Step 9 While components are soaking, use ½ of the

cleaner/water solution to clean all foodzone surfaces of

the ice machine and bin. Use a nylon brush or cloth to

thoroughly clean the following ice machine areas:

• Evaporator plastic parts – including top, bottom and

sides.

• Bin bottom, sides and top.

• Rinse all areas thoroughly with clean water.

Step 10 Mix a solution of sanitizer and warm water.

Solution Type Water Mixed With

Sanitizer 6 gal. (23 l) 4 oz (120 ml) sanitizer

Manitowoc URF0140A Technician's Handbook

Other manuals for Manitowoc URF0140A