4. Check for worn or damaged parts
Only perform repairs and maintenance
further works must be performed by a
16
Blower Care
AFTER USE
1. Switch the blower off, wait for moving parts to stop, remove the battery
and let it cool down.
2. Check, clean and store the blower as described below.
RULES FOR CARE
1. Keep the blower clean. Remove debris from it after each use and
before storage.
2. Regular and proper cleaning will help ensure safe use and prolong the
life of the blower.
3. Inspect the blower before each use for worn and damaged
parts. Do not operate it if you find broken and worn parts.
GENERAL CLEANING
1. Clean the blower with a dry cloth. Use a brush for areas that
are hard to reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3 bar/40 psi).
NOTE: Do not use chemical, alkaline, abrasive or other
aggressive detergents or disinfectants to clean this
blower as they might be harmful to its surfaces. Do not use
cleaning fluids or solvents or spray the machine down with
specially water und
water (e er pressure) when cleaning the
blower.
Always switch the blower off, wait for
moving parts to stop, remove the battery
and let the blower cool down before
performing inspection, maintenance and
cleaning work!
CAUTION!
work according to these instructions! All
qualified specialist.
Moving parts will continue to run for several
seconds after turning off the machine. Wait
until all moving parts have have completely
stopped before lifting the blower or conducting
inspection and maintenance.
Operator’s Manual
To Next Page
Loading...
Need help?
General
