EasyManua.ls Logo

Mantis 3559 - Troubleshooting; Recycling and Disposal

Mantis 3559
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
RECYCLING AND DISPOSAL
The product comes in a package that protects it against damage during shipping. Keep the package until you are
sure that all parts have been delivered and the product functions properly. Recycle the package afterwards.
WEEE symbol. Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or local store for recycling advice.
Problem Cause Remedy
1. blower does not start 1.1. Battery is not correctly inserted
1.2. Motor terminals or capacitor disconnected
1.3. Battery is empty
1.1. Remove the battery and reinsert
1.2. Check by a specialist electrician
1.3. Charge the battery
2. Blower does not reach full power. 2.1. Battery is close to empty
2.2. Air vents are blocked
2.1. Recharge the battery
2.2. Clean the air vents
3. Excessive vibration or noise
4.1. Impeller is damaged
4.2. Debris in impeller housing
4.1. Seek help from a qualified specialist
4.2. Remove the battery and attempt to
shake debris out of housing. Do not
insert anything into the housing. If you
are unsuccessful seek help from a
qualified specialist
4. The battery pack does not
charge properly
5.1 No power to the outlet.
5.2 Charger contacts are clogged with debris
or shorted with foreign material
5.3 Abnormal Temperature. The battery pack
is either too hot or too cold.
5.1 Make sure that the outlet is not
turned off.
5.2 Clean charger contacts
5.3 Move the charger and battery
pack to a location having room
temperature
Once the pack is within
the acceptable range, normal charging
will take place
Cordless Blower Troubleshooting
Suspected malfunctions are often due to causes that users can fix themselves. Therefore check malfunctions using this section. In most cases
the problem can be solved quickly.
Only perform the steps described within these instructions! All further inspection, maintenance and repair work must be
performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself! For
assistance contact the Mantis customer service center at 1-800-366-6268.
Operator’s Manual

Related product manuals