STARTING (continued)
}Starting a Warm clear return line. push primer
Engine bulb 3-4 rimes or untiJ fuel is
visible in the line.
I. Slide ignition switch to
START position. 4. Pul] starter rope using
2. Push choke bn_ton in to
the RUN (open) p_.osition.
3 If there is no fuel in the
short pulls. 1/2 m 2/3 of the
rope length.
5. If engl ne fails to start in 4
pulls, use "First Time" starting
procedure on page 10.
6. With engine running, a_cl
both hands on the handles
squeeze tbrottJe trigger
gradually m increase the engine
speed and engage the tines.
ADDI ONAL INFORMATION
A Tip for E×tending
Your Engine's Life
After you start, the engine, let
your filler warm up for two ro
three minmes beiore _ ou use it.
Then. before you put your tiller
away, let it idle }.br a minute to
give *he engi ne a chance to cool
do_@,l-i
How to Stop the
Engine
Simply push the start/stop
switch m "stop." (Picture 1)
This will stop the engi ne
instantly If it should ever fail to
do so_ .lust pull out the choke
button. The engine will stop at
once.
_bout the Choke
The choke controls the
arnoum of air drawn in1 o the
engine. Your tilter will run only
if the choke is open --- that is. if
the choke is pushed in.
A Special Feature
(with the idle set
properly and the
engine running)
Even when the engine is
running, the tines won't turn
unless you press the _hrottle
lever on the handlebars. An&
when you release the throttle
lever the tines will stop.
Picture t
To Next Page
Loading...
