o
Adjusting the volume balance
1
Press OPTION.
The option menu screen is displayed on the display.
2
Use Cursor Up/Down buttons to select “Trim”, then
press ENTER.
3
Use Cursor Left/Right buttons to select “Left” or
“Right”.
0
If you are using an F.C.B.S. connection, a screen for selecting the
F.C.B.S. ID (“Leader”, “Member 1”, “Member 2” or “Member 3”)
will appear after step 3. Use Cursor Up/Down buttons to select
the ID of the device you want to set, then press ENTER.
4
Use Cursor Up/Down buttons to adjust the volume
balance.
Left:
-∞ (minimum), -19.0 - 0 (maximum)
(Default: 0)
Right:
-∞ (minimum), -19.0 - 0 (maximum)
(Default: 0)
0
When the input source is set to “Power Amp Balanced” or “Power Amp
Unbalanced”, the volume balance adjustment function does not work.
0
When the source direct mode is turned on, the volume balance adjustment
function does not work.
0
When the source direct mode is turned on, the “Trim” setting is set to 0
(maximum).
Contents Connections Playback Settings Tips Appendix
43
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
