Playback in source direct mode
The signal does not pass through the tone adjustment circuitry, resulting in
playback of a higher sound quality.
1
Press DIRECT to turn on source direct mode.
“Source Direct” is displayed on the display.
0
When the input source is set to “Power Amp Balanced” or “Power Amp
Unbalanced”, the source direct function does not work.
Switching the display’s brightness
The display brightness can be adjusted from 100 % to Off (0 %) in steps of
5 %. Switching the display off reduces a source of noise that affects sound
quality, enabling higher sound quality playback.
1
Press DIMMER.
The dimmer menu screen is displayed on the display.
2
Use Cursor Up/Down buttons to adjust the brightness
of the display.
0
You can also adjust the brightness by pressing DIMMER.
0
If button operations are made while the display is off, information is temporarily
displayed at 100 %.
0
The display brightness is set to 100 % by default.
0
The display brightness setting is synchronized with the “Illumination” - “Display”
setting in the settings menu. (v p. 49)
0
DIMMER does not work when LIGHTING is pressed and turned off.
Contents Connections Playback Settings Tips Appendix
44
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
