Marantz 6300 - Page 9

CONNECTION
TO AMPLIFIER
Plug the left and right output cables into the
PHONO jacks of your preamplifier or receiver.
(The red plug is the right stereo channel.)
Connect the ground wire which runs in between
the two output cables to the CHASSIS GROUND
BINDING POST of your receiver.
NOTE: Depending on the cartridge there may be
occasions where it is more advantageous
to leave the ground wire disconnected.
Connect your turntable in the condition
which produces the best performance.
Then, plug the AC power cord into an outlet
supplying the proper voltage, or into one of the
SWITCHED convenience outlets on the back of
your receiver.
SIMPLIFIED OPERATING
PROCEDURES
MANUAL OPERATION
1. Turn on your amplifier system and select the
Model G300 Turntable as the source input.
2. Place a record on the turntable. Fora 45 RPM
record, fit the supplied adaptor over the
turntable center spindle.
3. Select the desired speed (33 or 45).
4, Place the turntable in MANUAL mode (push-
switch released).
5. Depress the POWER switch. The turntable will
rotate. While the record is turning, you may
wish to clean its surface with a suitable
cleaning device before playing.
6. Take the arm out of the arm rest and position
the stylus directly above the desired groove.
7. Press the DOWN pushbutton. The stylus will
slowly descend to the selected groove. A small
amount of practice will enable precise record
cueing.
8. To lift the tone arm at any time, press the UP
pushbutton.
9. To stop the turntable, press and release the
POWER pushswitch.
AUTOMATIC OPERATION
When in the AUTO mode the tone arm will lift
up and the turntable will stop automatically when
the record has finished playing. Operation is as
follows:
1. Depress the AUTO/MANUAL pushswitch.
2. Depress the POWER switch. The turntable will
not rotate, yet.
3. Position the stylus over the first groove of the
record.
4. Press the CUE DOWN button. Now the turn-
table will start, and the arm will slowly
descend. By the time the stylus contacts the
disc, the turntable will be up to speed,
5. When the record finishes playing, the arm will
lift and the turntable will stop.
6. To lift the arm and stop the turntable before
the end of the record, press the CUE UP
pushbutton,
If you wish to clean the record as it rotates on the
turntable, leave the arm on the arm rest and press
the DOWN pushbutton, or temporarily put the
turntable in MANUAL mode.
=