PREPARATION 17
ENGLISH
Connecting to optional equipment
Connecting to an amplifier equipped with two channel
analog stereo
● Connect the audio Left and Right out jacks of the DVD player to the
audio left and right in jack on your amplifier, receiver or stereo system,
using the optional audio cable (D).
Connecting to an amplifier equipped with two channel
digital stereo (PCM)
1 Connect the player’s digital audio out jack (optical F or coaxial E) to the
corresponding in jack on your amplifier.
Use an optional digital (optical F or coaxial E) audio cable.
2 You will need to activate the player’s digital output (see ‘Personal
Preferences’).
Connecting to an A/V receiver equipped with a multi-
channel decoder (Dolby Digital™(AC-3), MPEG 2 and
DTS)
Digital Multi-channel sound
Digital multi-channel connection provides the best sound quality. For
this you need a multi-channel A/V receiver that supports one or more
of the audio formats supported by your DVD player (MPEG 2, Dolby
Digital
™
(AC-3) and DTS). Check the receiver manual and the logos
on the front of the receiver.
1 Connect the DVD player’s digital audio output (optical
F
or coaxial
E
) to
the corresponding input on the receiver using an optional digital (optical
F
or coaxial
E
) audio cable.
2 You will need to activate the player’s digital output (see ‘Personal
Preferences’).
Note:If the audio format of the digital output does not match the
capabilities of your receiver, the receiver will produce a strong,
distorted sound or no sound at all. The selected audio format of
the DVD is displayed in the Status Window when the SETUP OSD
is activated or Audio button is activated.
Six Channel Digital Surround Sound via digital connection can
only be obtained if your receiver is equipped with a Digital Multi-
channel decoder.
To see the selected audio format of the current DVD in the Status
Window, press the SETUP OSD or the Audio Language selector
button.
To Next Page
Loading...
