Marantz HD-CD1 - Page 46

4. Run the FLASH MCU Programmer
(1) Press the power button to turn on the power.
(2) Execute "
FUJITSU FLASH MCU Programmer for FM3/FM4
" after installing it on your computer.
(1) Double-click
FLASH MCU Programmer
to launch
FLASH MCU Programmer
Start.
(3) Target MCU : Select "
MB9AF344L/M/N
"
Crystal Frequency : Select "
4MHz
"
Hex File : Select the le to be "
Update
"(HD-CD1_XXXXXX-XX.hex)
Click "
Full Operation(D+E+B+P)
"
(4) Click "
OK
".
MB9AF344L/M/N
XXXXXX_XXXXXX-XX.hex
4MHz
(5) The following display appears when the rmware update is complete.
Click "
OK
".
(6) Initialize this unit.
Remove the AC plug.
While holding down buttons the "
5
" and "
3
" buttons simultaneously, insert the AC plug to turn the
power on.
(7) After updating the rmware, check the version.
See "1. Version Display Mode"
46
Caution in
servicing
Electrical Mechanical Repair Information Updating