Need help?Do you have a question about the Marantz MA700 and is the answer not in the manual?
General| Total Harmonic Distortion (THD) | 0.03% |
|---|---|
| Input Impedance | 47 kΩ |
| Input Sensitivity | 1.2V |
| Damping Factor | 100 |
| Weight | 15.4 lbs |
Describes the MA700 as a monaural power amplifier for hi-fi AV systems.
High-power amplifier with discrete circuits, rated 200W/8-ohm or 300W/4-ohm.
Narrow front panel design for reduced installation area; 435mm width for three units side-by-side.
Small space requirement ideal for extension amplifier for AV components like Dolby Surround processors.
Supports MARANTZ remote control for power adjustment from compatible preamplifiers.
Unit power can be switched by remote control using a video signal or DC signal.
Invert output jack provided for BTL connection of two MA700 units.
Unit is THX certified.
Button to turn the unit ON or OFF. Leave ON for remote control.
Lights up when the unit is ON and ready to output sound; blinks during mute.
Lights up when the unit is in STANDBY mode via remote or video signal.
Connects the preamplifier output to the unit.
Sets amplifier output level by adjusting input level; used for balance between units.
Connects master unit's invert output to slave unit's input for BTL connection.
Sets unit to 'MASTER' or 'SLAVE' for BTL connection; bypasses input level for balance.
Connects to MARANTZ remote control output for power ON/STANDBY control.
Connects to MARANTZ remote control input for system control.
Outputs remote control signal with a delay to prevent simultaneous power-on of multiple units.
For controlling power ON/STANDBY based on video signal presence or absence.
Connects speakers; respect polarity; use 4-16 ohm impedance speakers.
Supplies AC power; total consumption must not exceed 250W.
Connects the unit to a 120V AC household outlet.
Diagram illustrating the 6-channel connection from preamplifier to multiple speakers.
Set the BTL switch to 'MASTER' for BTL connection.
Set the BTL switch to 'SLAVE' for BTL connection.
Ensure the power switch is OFF before connecting speaker cables.
Use a speaker cable with flame retardant rating of Type SPT-2 or more.
Do not strip more insulation than shown for terminal connection.
Steps for loosening, inserting core, and tightening terminals for speaker cable.
Instructions for cleaning the unit's exterior using soft, lint-free cloths.
Check if the power cable is properly plugged into the AC outlet.
Check if speaker cables and input cables are connected properly.
Lists the width, height, and depth of the unit.
Lists included accessories such as remote control cable and speaker cable.
To Next Page
