10
ENGLISH
Loading Batteries
Insert the three supplied batteries (AAA type)
as shown in the figure below. Load the
batteries with the polarity in the correct
direction (plus + and minus - ends).
1 Remove the back cover.
2 Insert the new batteries (AAA type) with
correct and polarity.
3 Close until it clicks.
Note:
Do not use old batteries and new batteries
together. This can result in corrosion or
leakage of battery fluid.
The supplied manganese batteries are for
checking operation. Usage of alkaline
batteries is recommended.
When discarding batteries, be sure to
follow the local regulations for your area.
Do not put batteries in a fire.
RC1400N01ENG 03.10.6, 4:17 PMPage 10 AdobePageMaker6.5J/PPC
To Next Page
Loading...
