Macro Page Notation
Before you begin to program a Macro, study the notation used in
the MACRO mode. Each type of action has its own notation.
User Guide
42
Reference
6. Programming Macros
DVD/...
- When the device name
with “/...” is listed, the
macro step will be a
Device Action (the action
that occurs when the
Device is selected, which
is typically the
receiver/preamp’s source
selection or input com-
mand).
GO: DVD Main
- A Go command indi-
cates a panel jump. In
this case, “DVD” means
a jump to the DVD
device and Main is the
name for the particular
panel (sometimes pan-
els just have numbers,
not names).
A/V Amp ON - When
a device name and a
button name are listed,
that particular button’s
IR command will be
issued.
DVD
■■
- A device name and the
Stop symbol means that
this particular button’s IR
command will be issued.
The symbol list can be
found on page 54.
Delay 0.5
- A delay counts as one
of the 250 macro steps.
Delays can be adjusted
in 0.1 second intervals
to be any value between
0.1 second to 10.0 sec-
onds.
Adjusting Delays
- When a delay is
“Selected,” you can
adjust the delay with
the + and - buttons.
Beep - A beep counts
as one of the 250 macro
steps. Useful to notify
when the macro execu-
tion is finished
To Next Page
Loading...
