User Guide
59
Troubleshooting
General Problems
The display is blank
■ Tap the screen to make sure the RC9500 is turned on.
■ Adjust the screen brightness using the buttons on the left side.
(page 17)
■ Make sure the battery pack is properly installed. (page 4)
■ Recharge the battery pack using the docking station. (page 5)
The display is too light or too dark
■ Adjust the screen brightness using the buttons on the left side.
(page 17)
The RC9500 shuts itself off
■ This is a feature of the RC9500 to save power. You can change
the length the RC9500 stays on in the Setup. (page 13)
Devices do not respond to commands from the RC9500
■ Make sure the RC9500 is in USE mode. (page 7)
■ Make sure the RC9500’s IR sending eye is pointed towards the
device you’re operating.
■ Check if the Low Battery icon appears. If so, recharge the bat-
tery pack using the docking station. (page 5)
■ Check if the button you are trying to use is programmed proper-
ly. (page 18)
■ Check if your device understands these particular Marantz
infrared codes. Re-add the device with the correct model num-
ber. (page 35)
To Next Page
Loading...
