User Guide
63
Frequently Asked Questions
How do I calibrate the Touch Screen?
The RC9500 is calibrated when it leaves the factory, so normally
you do not have to calibrate it yourself. It is possible that the
RC9500 displays a message to calibrate the Touch Screen. If this
message appears do the following.
1 Tap the INFO button in the Upper Tool Bar.
The information page will appear.
2 Tap the “SETUP” button in the Information page.
The first Setup page appears.
Navigate to third Setup page by using the Page + and Page -
buttons.
3 Tap the “Calibration” button.
4 You will see the instruction “Tap TOP LEFT corner”.
Tap as close as possible the marker in the top-left corner using
a blunt tip of a pencil.
5 You will see the instruction “Tap BOTTOM RIGHT corner”.
Tap as close as possible the marker in the bottem-right corner
using a blunt tip of a pencil.
6 You will see the instruction “Tap TOP RIGHT corner”.
Tap as close as possible the marker in the top-right corner using
a blunt tip of a pencil.
7 You will see the instruction “Tap BOTTOM LEFT corner”.
Tap as close as possible the marker in the bottom-left corner
using a blunt tip of a pencil.
8 You will see the message “Calibration succeeded”.
9 Return to USE mode by tapping the INFO button again or
press the Left Function button labeled “Exit“.
To Next Page
Loading...
