129
Appendix
Tips
Settings
Connections
Contents
Front panel Display Rear panel IndexRemote
Playback
Playback in ZONE2
POWER
VOLUME
MUTE
ZONE2
X
Input source select
buttons
1
Press ZONE2 to switch the zone mode to the ZONE2.
2
Press POWER X to turn on the ZONE2 power.
The ZONE2 power indicator on the display lights (vpage15).
•Also press input source select button when in standby mode, the
power turns on.
•When POWER X is pressed, ZONE2 turns o.
•Power in ZONE2 can be turned on or o by pressing ZONE2 ON/
OFF on the main unit.
3
Press the input source select button to select the input
source to be played.
The audio signal of the selected source is output to ZONE2.
•In ZONE2, you can select iPod/USB, TUNER, NETWORK, M-XPort
or an input source with an analog audio input connector.
•Turn INPUT SELECTOR after pressing ZONE2 SOURCE on the
main unit to select an input source.
2 Adjusting the volume
Use VOLUME df to adjust the volume.
•At time of purchase, “Volume Limit” (vpage 178) is set to “70
(–10dB)”.
%
•Turn VOLUME after pressing ZONE2 SOURCE on the main unit to adjust the
sound volume.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
