Need help?Do you have a question about the Marantz SR7100DC and is the answer not in the manual?
General| Channels | 5.1 |
|---|---|
| Input Sensitivity | 200 mV (Line) |
| Speaker load impedance | 4 - 16 ohms |
| Power Output | 100 W per channel (8 ohms) |
| Tuning range | FM |
| Total Harmonic Distortion (THD) | 0.08% |
Steps for aligning the audio stage of the receiver.
Steps for aligning the FM tuning stages.
Specific procedures for FM Radio Frequency alignment.
Specific procedures for AM Radio Frequency alignment.
Specific procedures for AM Intermediate Frequency alignment.
Procedure for aligning the PLL oscillator circuit.
Schematic and component layout for the Tuner/Phono amplifier board.
Schematic and component layout for the PLL/LPF board.
Schematic and component layout for the controller board.
Schematic and component layout for the main amplifier sub-board.
Schematic and component layout for the main amplifier board.
Schematic and component layout for the power supply board.
Exploded view and parts list for chassis and general internal parts.
Exploded view and parts list for P.W. boards and other internal components.
List of parts for the P100 Tuner/Phono Amplifier circuit board.
List of capacitors used on the P100 board.
List of resistors used on the P100 board.
List of semiconductors used on the P100 board.
List of capacitors used on the P500 board.
List of parts for the P501 PLL/LPF circuit board.
To Next Page
