How to stop noise heard during FM reception on Marantz Stereo Receiver?
If you're experiencing noise during FM reception with your Marantz Stereo Receiver, it could be that the radio waves from the broadcasting station are weak. Try installing an FM outdoor antenna.
Why DTS sources cannot be played on Marantz SR8000 Stereo Receiver?
If you cannot play DTS sources on your Marantz Stereo Receiver, it might be because the Surround mode is set to DOLBY. Try selecting another mode. It could also be that your DVD or LD player is not DTS digital out capable, so use a player which responds to DTS-digital out.
Why surround mode cannot be changed on Marantz SR8000 Stereo Receiver?
If the surround mode cannot be changed on your Marantz Stereo Receiver, it may be because headphones are connected to the jack. Disconnect the headphones, as the surround mode will be fixed to STEREO when headphones are connected.
What to do if Marantz SR8000 Stereo Receiver skips during play of a DTS source and produces noise?
If your Marantz Stereo Receiver is skipping during the play of a DTS source and producing noise, it may be due to a data error that occurred during the player skip. Try setting the Surround mode to DTS-cinema or DTS-music.
Why a 96kHz PCM signal cannot be played on Marantz SR8000?
If a 96kHz PCM signal cannot be played on your Marantz Stereo Receiver, it could be that the disc player is not 96kHz PCM digital out capable, so use a player that responds to 96kHz PCM digital out. Additionally, check if the Surround mode is set to other than STEREO and AUTO; if so, set the Surround mode to STEREO or AUTO.
What to do if Marantz Stereo Receiver cannot play a normal PCM signal (CD or laser disc)?
If a normal PCM signal (CD or laser disc) cannot be played on your Marantz Stereo Receiver, the Surround mode might be set to DTS-cinema or DTS-music. Select another mode.
General| Brand | Marantz |
|---|---|
| Model | SR8000 |
| Category | Stereo Receiver |
| Language | English |
To Next Page
