12
2.2.2 Preparation for use of the product «Type 02».
WARNING! THE NORMAL CONDITION OF THE PRODUCT OF THE «TYPE 02» (OWN
ELECTROSHOCK DEVICE) - THE FUSE IS ON (THE FUSE INDICATOR IS OFF). REMOVE THE ESD
FROM THE FUSE IMMEDIATELY BEFORE TURNING ON THE ESD.
The fuse also serves as a charge indicator.
2.2.3 Charging of the battery is described in the operating
manual of the electroshock device AIR-107 «SCORPION-A»
(350)
SMKP30.00.00.00.000 OM.
2.2.4 Charging of the battery of the product. «Type 02».
To charge the battery (8), it is necessary to unscrew the
pin (18) located in the front-end part of the battery housing
(compartment), remove the housing (17), attach the cord
of the external charger to the battery plug (19) and turn on
the external charger to the household power grid (~220 V,
50 Hz). Check for a network connection by means of
the indicator (15) located on the left side of the housing
(compartment). If the indicator does not light up, it is
necessary to check the contacts of the charging cord and
plug, as well as the availability of power in the mains.
Before the first use of the product, it is necessary
to
charge the battery for 8 hours. In the future, before
using
the product, it is necessary to make sure that the battery is
Рис. 8
18
17
15
19
To Next Page
Loading...