ASSEMBLY INSTRUCTION
STEP 1
Attach rear stabilizer (3) to main frame (1), tighten with two curved washers (4), domed nuts
(5) and carriage bolts (2). Then attach the front stabilizer (6) to the main frame (1), tighten
with two carriage bolts (2) ,curved washers (4) and domed nuts (5).
2
5
4
4
6
5
5
5
4
4
3
2
STEP 2
Connect the extension lower sensor wire (49) with the middle sensor wire (55).
Turn the tension control knob w/cable (51) to level 8, connect it to extension tension
cable (50).
Insert the front post (9) into the main frame (1) and secure using four allen bolts (47)
and four curve washers (54).
9
54
54
47
47
55
51
50
49
1
To Next Page
Loading...
