Mares Nemo WIDE - Time Settings and Diving Modes; Time, Date, and Temperature Adjustments; Predive Mode - Air Dive

36
SET  BOTTOM TIME  AL BEEP
This function enables or disables the audible alarms.
When the computer is turned on, it displays the
current setting (“ON” or “OFF”).
Use the <+> or <-> buttons to change the setting.
Press <ENTER> to save and return to Set – Mode.
CONTROLLING THE TIME
SETTINGS
In this menu you can control the current watch data,
date and temperature.
You can access the TIME option from the main menu
using the <+> and <-> keys. Press <ENTER> to accept
the TIME selection.
The current time will be displayed. Press <+> or <->
to view the temperature and current date (Fig. 10).
FIG. 10
Press the <ESC> button to return to the main menu.
From this menu you can also directly access the
setting for adjusting the watch, and from here
you can adjust the time and date. Hold down the
<ENTER> button for two seconds when the date
or time appears. You can also enter the dive data
setting by pressing <ENTER> for two seconds when
the temperature reading appears.
DIVING WITH NEMO WIDE
!
WARNING
We advise that when diving you always put
Nemo Wide into Predive mode.
Always check that the dive computer is
switched on early in your dive.
Nemo Wide manages three types of dives:
AIR
EAN
BOTTOM TIME (Gauge)
To help clarify Nemo Wide functions during the
dive, the display screens have been grouped into
four phases:
Predive
Dive
Surfacing
Surface mode
PREDIVE  AIR
This operating mode remains active until the diver
goes below 1.2 meters (4 ft). The following details
are displayed (Fig. 11):
• type of dive (AIR);
• units of measurement (m-°C or ft-°F);
• type of water (Salt, Fresh);
• altitude program (if enabled) and level;
• personal correction factor (if enabled) and level.
FIG. 11
NOTE
Before every dive, it is advisable to
enter Set Dive mode and check all the
parameter settings.
DIVE  AIR:
“NODECOMPRESSION” DIVE
When the diver descends below 1.2 meters (4 ft)
Nemo Wide automatically switches to Dive Mode
and starts displaying the dive data. If this mode
persists for more than 20 seconds, Nemo Wide will
begin recording the dive details in the Log Book
memory.
The following details are displayed (Fig. 12):
• current depth (in “m” or “ft”);
• no decompression time remaining, expressed in
minutes;
• “No deco” icon;
• icons for the altitude program and personal
correction factor (if enabled).
2334-Nemo Wide-ing-rev.indd 362334-Nemo Wide-ing-rev.indd 36 19/09/2006 11.09.4919/09/2006 11.09.49
JoeDiverAmerica.com