33
DIVE COMPUTER NEMO WIDE
Press <ENTER> to enter the set.
SET DIVE DATA
SET DIVE DATA FRESH / SALT
!
WARNING
Before diving, make sure you have correctly
set the units of measurement. An incorrect
setting may give rise to confusion during
the dive, and hence to underwater behavior
errors.
To ensure maximum accuracy, you need to set Nemo
Wide for either fresh water (“Fresh”) or seawater
(“Salt”) as appropriate. Check this setting often,
especially if you use the instrument in a variety of
environments (lake, sea, swimming pool).
Use the <+> or <-> buttons to adjust the values.
Press the <ENTER> button to save the changes
made and move to the next selection.
The <ESC> button exits to the previous set.
SET DIVE DATA °C METERS / °F FEET
You can select which units of measure you want to
use: metric (°C and m) or Imperial (°F and ft).
Use the <+> or <-> buttons to adjust the values.
Press the <ENTER> button to save the changes
made and move to the next selection.
The <ESC> button exits to the previous set.
SET DIVE DATA DEL TISSUE
!
WARNING
This option is intended only for highly
experienced divers. Users who clear the
residual nitrogen memory cannot use the
instrument for repetitive dives. After this
operation, do not dive with Nemo Wide if
you have already dived within the previous
24 hours.
This item is used for clearing the residual nitrogen
memory of the tissue compartments.
In Set Dive - Data mode, scroll until the blinking
“DELETE” message appears.
Press <ENTER> to call up the confirmation option,
which will show a blinking “NO” message. Use the
<+> or <-> buttons to change to “OK”.
Then, once the “OK” message is displayed, press
<ENTER> to clear the residual nitrogen in the tissue
compartments.
If you do not wish to clear the residual nitrogen
memory in the tissue compartments, press <ENTER>
when “NO” is displayed.
The <ESC> button exits to the previous set.
Press the <ENTER> button after the last item to
return to the Set dive - Data menu.
Now we can move to the Set dive - Mode using the
<+> and <-> keys.
SET DIVE MODE
Set Dive - Mode is used for setting the general
parameters for the planned type of dive.
Press ENTER to access this menu.
Here you can select the dive you have planned and
adjust the corresponding parameters accordingly.
The last operational mode will appear selected
from among:
• AIR
• EAN
• BOTTOM TIME
Use the <+> and <-> keys to choose the dive type
desired.
NOTE
If you have completed an EAN dive and
wish to do a repetitive dive with air, set
the computer for “EAN” with O
2
at 21%.
By so doing, the calculation of the % CNS
will remain active.
AIR
This section covers dives using compressed air as
the breathing mix. When you see the word AIR, in
Set dive - Mode, press the ENTER button. First of all,
you can adjust the altitude.
SET AIR ALTITUDE
Altitude programs:
P0
(0-700 m) (0-2296 ft)
P1
(700-1500 m) (2296-4921 ft)
P2
(1500-2400 m) (4921-7874 ft)
P3
(2400-3700 m) (7874-12139 ft)
When this item is accessed, it displays an indication
of the current altitude program (P0, P1, P2, P3)
(Fig. 5). Use the <+> or <-> buttons to enter the
ENGLISH
2334-Nemo Wide-ing-rev.indd 332334-Nemo Wide-ing-rev.indd 33 19/09/2006 11.09.4819/09/2006 11.09.48
To Next Page
Loading...
