Mares Puck - EAN Decompression Stop Dives

41
PUCK DIVE COMPUTER
ENGLISH
NOTE
Hold down the button for 4 seconds to
activate the display backlight.
DIVE - EAN: “DECOMPRESSION
STOP” DIVE
If the diver does not ascend when the residual time
has expired, PUCK switches to “decompression
stop” mode, indicated by the appearance of
the “deco” message and by an audible alarm.
The following data are displayed in this mode
(Figure 23):
• “Deco” icon
• Current depth (in “m” or “ft”)
• Depth of deepest decompression stop
(in “m” or “ft”)
• Duration of the deepest decompression stop
• The DEEPSTOP icon (if the stop is required)
• The Ascent time
• Altitude program and level (if enabled)
• Personal correction factor and level
(if enabled)
• The % CNS
• The duration of the dive so far (dive time) in
numbers
FIG. 23
Pressing the button will display (Figure 24):
• The maximum depth reached
• DEEPSTOP icon
• The DEEPSTOP if applicable
• Altitude program and level (if enabled)
• Personal correction factor and level
(if enabled)
FIG. 24
Pressing the button again will display (Figure 25):
• “Deco” icon
• Current depth (in “m” or “ft”)
• Depth of deepest decompression stop
(in “m” or “ft”)
• Duration of the deepest decompression stop
• The current temperature
• The DEEPSTOP icon (if the stop is required)
• Altitude program and level (if enabled)
• Personal correction factor and level (if enabled)
FIG. 25
Pressing the button again will display:
• Type of dive (EAN)
• Altitude program and level (if enabled)
• Personal correction factor and level (if
enabled)
• Units of measurement (m-°C or ft-°F)
• Type of water (Salt, Fresh)
• The %O
2
NOTE
During the dive, when the button
is pressed, PUCK will display the
estimated DEEP STOP required. The
data displayed during the ascent may
vary as a result of the diver’s behavior.
Divers should check this data during
the ascent for more precise information
on the estimated stop.