MARIMEX ProStar 3 - Problem Treatment; Sand Contaminated with Dirt; Pump Sucks Air; Skimmer or Pump Gets Too Little Water

2120
Problem treatment
Cause of Problems Solution
Sand contaminated with dirt Backwashing (cleaning of the sand)
Pump sucks air
(Bubbles at the inlet)
defective hoses,
tighten hose clamps
Skimmer or pump gets too little water
Check water level and increase if necessary,
check the intake for dirt accumulation
Skimmer basket contaminated Cleaning of the skimmer basket
Prelter basket of the lter pump contaminated Cleaning oft he prelter basket
To Winterize the System
At the end of the swimming season, the lter system and the hoses must be
removed and emptied.
This is done when the lter vassel as well as the lter pump by opening the drain
plug. Open the lter vessel and empty the lter sand. Verify that the lter sand is
still in reasonable condition (not glued or clumped) and clean it.
Filter systems located outdoors must be located in afrost-free room in the winter.
Care instructions
Visible contaminants are removed through the ltration system. This is not true
for algae, bacteria and other microorganisms, which are also aconstant threat to
clear, clean and healthy pool water. For their prevention or removal, special water
treatment is available, properly and permanently dosed, guarantee for swimmers
any kind of harassment and ensure proper hygienic bath water.
Contact information
www.marimex.cz
+420 261 222 11
e-mail:
info@marimex.cz
With every switching of the 6-way valve the lter
pump must be turned o!
Filter run time (2 x 4 – 5 hours aday) and the regular backwashing
(2 – 3 minutes) at least 1 x per week as well as the oorcleaning are
the basic requirement for maintained swimming pool water!
Repairs on the pump should only be performed by trained and qualied,
professional technicians.
Specications:
All models:
6-way valve, lter pump TÜV / GS, lter vessel, connection Ø 32/38
mm, base plate
Model ProStar 3
Flow rate: 3,8 m³/h at 0,4 bar working pressure
Connection: 230 V, max. 200 W
Amount of Sand: max. 10 kg
Pool size: max. 19 m³
Filter pump: with prelter, not self-priming
Floorcleaning (Illustration 8)
Floorcleaning is done in position FILTER (on the valve). The pooloor vacuum
cleaner has to be connected with the pool-oor vacuum cleaner hose directly to the
skimmer. Until the pool-oor vacuum cleaner is connected and ready for operation,
the lter pump must be switched o.
Important: The pool-oor vacuum cleaner hose must fully be lled with water so
that the pump does not lter air, only then the pump can be switched on. Will air
get into the lter system, the lter pump is to turn o and the vacuum cleaner
must be vented again.
Now move slowly and smoothly (speeding can stir up dirt) with your vacuum
cleaning brush on the bottom of the pool.
For lter systems without prelter askimmer with astrainer basket is benecial!
EN