MARIMEX ProStar 6 - User Manual

Questions and Answers

T
Terry ContrerasAug 14, 2025
Why is there sand in my MARIMEX ProStar 6 pool?
- E
  elizabethlaraAug 14, 2025
  If the sand fill is new, the grains in it might be smaller than the set size. In this case, repeat the back washing operation several times until the backwashing water is clean. Sand in the six-way valve (residues from backwashing) can also cause this issue. To resolve this, set the position to “Backwashing” and pump water to drain for approximately 30 seconds. Alternatively, the partition dividing the chamber for cleaned water might not be correctly installed, so check the installation. Finally, the bottom screen could be damaged, requiring you to change it.
D
Daniel GrayAug 17, 2025
What to do if the MARIMEX ProStar 6 Lighting Equipment pump motor does not run?
- Z
  zimmermanraymondAug 18, 2025
  First, ensure the plug is properly inserted into the socket. If that's not the issue, check if the earth-leakage circuit breaker has tripped and switch it. If it immediately trips again, the pump motor is likely defective and needs to be changed.
R
reedkaitlynAug 21, 2025
What to do if my MARIMEX Lighting Equipment pressure gauge shows higher pressure than 1 bar?
- F
  Felicia RosalesAug 21, 2025
  If the pressure gauge displays a pressure higher than 1 bar, it may be due to a clogged sand fill. To resolve this, perform a backwashing operation.
L
Logan HayesAug 25, 2025
What to do if water flows to the waste in my MARIMEX ProStar 6 Lighting Equipment?
- M
  Manuel DavisAug 25, 2025
  If water is flowing to the waste, it indicates impurities around the sealing of the six-way valve. To fix this, unscrew the six-way valve from the filtration vessel lid and clean the sealing.
B
Bonnie GrantAug 27, 2025
How to fix leaks at hose connections in MARIMEX Lighting Equipment?
- E
  edwardcruzAug 27, 2025
  Leaks at hose connections usually indicate leaks at the seating faces of hose connections. To fix this, re-stuff the hose studs using Teflon tape.
J
Jose MorrisAug 30, 2025
What to do if I see water outflow from the waste socket of MARIMEX Lighting Equipment?
- C
  Charles BarryAug 31, 2025
  Water outflow from the waste socket means that valve seating faces are damaged. In this case, have the valve repaired.
E
Erica BrownSep 3, 2025
Why does my MARIMEX ProStar 6 have too low pressure?
- C
  Caleb AguilarSep 3, 2025
  Too low pressure is often caused by a clogged screen of the pump's coarse preliminary filter. You should clean the coarse preliminary filter screen.
A
Anna DavisSep 6, 2025
How to fix filtration vessel leakage in MARIMEX Lighting Equipment?
- M
  Michael BrowningSep 6, 2025
  Filtration vessel leakage is often caused by defective sealing. Check the sealing and replace it if necessary.
T
tjohnsonSep 10, 2025
How to remove air lock in coarse preliminary filter of MARIMEX Lighting Equipment?
- H
  hughesmatthewSep 10, 2025
  An air lock in the coarse preliminary filter is caused by leaks at the suction side. Tighten hose clamps and PVC joints to resolve this issue.