Series DC Digital Controllers
6
3.3 Connecting Power
Plug one end of the power cord into its receptacle at the rear of the controller
and the other end into a wall outlet with local earth ground (3-prong connector).
Before turning on power, the following safety checks and procedures should be
performed:
1. Never operate the controller if there is any visible damage to the power
cord or the test stand. The controller is powered by 110V/220V. Any
contact with this high voltage can cause serious injury or even death.
2. Ensure that the controller is kept away from water or any other
electrically conductive liquids at all times.
3. Make sure the electrical outlet powering the controller has local earth
ground (3-prong connector).
4. The controller should be serviced by a trained technician only. Power
must be disconnected before the controller is opened.
After the above safety checks and procedures have been performed, the
controller may be powered on and is ready for operation.
To Next Page
Loading...
Need help?
General
