Mark Levinson 31 - Remote Control Indicators and Battery Access

16
5 Transmit LED
This LED indicates when a command is transmitted by the Remote
Control. It lights when you press any button on the Remote Control.
Note: This LED indicates when the Remote Control sends a
command, not necessarily that the Nº31 received it.
If this LED fails to light when a button is pressed, replace the
Remote Control's batteries. (See "Set-up and installation.")
6 Battery compartment cover
This cap covers the compartment that holds the Remote Control's
batteries.
+
+
–
–
(Rear of
Remote Control)
Using the supplied 1/16" hex key, remove the two screws securing
the cover. Insert two AA batteries according to the symbols on the
inside of the battery compartment cover. Replace the battery
compartment cover.