Mark Levinson 31 - Customizing Link Settings and Index Options

43
The Nº31 allows you to change the Index 0 option and six of its link
settings to suit your own preferences.
Note: The polarity link setting is always on , and can't be
changed.
1. Make sure that the main power switch is set to the "on" ("|")
position.
2. Enable the Nº31's controls by pressing standby.
Note: To change your Nº31's link settings, your Mark Levinson
digital processor also must be connected (linked) and turned
on.
3. Press the front-panel display mode button and hold it until SET
OPTIONS appears on the Display.
If you continue holding the display mode button, the Display will
show each of your Nº31's options, in this order:
INDEX 0 –
RECORD LINK –
MUTE LINK –
STANDBYLINK +
+ indicates that the option is turned on
ALIAS LINK + – indicates that the option is turned off
PLAY LINK +
DISPLAYLINK +
If you continue holding display mode after the Display shows
DISPLAYLINK+, the links are shown again beginning with INDEX 0 –,
then RECORD LINK–, then MUTE LINK–, and so on.
4. When the Display shows the link setting you want to change,
release the display mode button.
If you release display mode too soon, simply press display mode
once to move to the next link.
Note: In several seconds, if you make no changes to the link
settings, the Display will go back into its standard mode. To
return to SET OPTIONS, repeat step 3.
5. To turn the link on , press the program + button; to turn the link off ,
press the program – button.
6. Repeat steps 4 and 5 for each link setting you want to change.
When you've finished, wait several seconds for the Display to
return to its standard mode.
Your link settings remain in memory when you place the Nº31 into
standby, when you turn off the main power switch — even if AC
power is interrupted.
Changing link settings