Market Forge Industries STM-E

Questions and Answers

F
fbarnettAug 8, 2025
What to do if my Market Forge Industries STM-E sterilizer won't turn on?
- J
  John HallAug 8, 2025
  If your sterilizer isn't operating and there's no pressure build-up, here's what you can check: * First, ensure it's installed correctly by checking the wire diagram. * Second, replace the fuse, and if it blows again, verify the electrical supply is 60 amps. * Third, the contactor may be burned out, in which case it should be replaced. * Finally, inspect all wiring for defects and repair or replace as necessary.
E
Elizabeth RobertsAug 14, 2025
Why my Market Forge Industries Laboratory Equipment sterilizer is not building pressure?
- R
  reedmarthaAug 14, 2025
  If your sterilizer operates but fails to reach 15.5 PSI pressure, consider the following: 1. The current may not be heating all elements. Remove the lower front panel to check if the heating elements are working. 2. The steam trap may not be closing. Replace the thermometer within the steam trap. 3. The exhaust valve may not be holding pressure. Check and readjust the temperature control if it's incorrectly adjusted. 4. Steam could be leaking around the door. Inspect the gasket for wear or adjust the door. 5. The safety valve might be blowing off prematurely. Replace the safety valve.
B
Beth GrantAug 20, 2025
How to fix Market Forge Industries STM-E Laboratory Equipment heating elements staying on?
- A
  Allison FryAug 20, 2025
  If one or both sides of the cast-in heating elements remain on when the timer is off: * The contactors of the temperature control switch may be stuck closed, requiring switch replacement. * Alternatively, the temperature control might not be properly calibrated, so recalibration is necessary.
A
Anthony GonzalezAug 27, 2025
What to do if Market Forge Industries STM-E Laboratory Equipment releases pressure too early?
- E
  Edward CarterAug 27, 2025
  If your unit releases pressure before the cycle has completed, the low water cut-off may have functioned prematurely. If so, replace the low water cut-off.
J
Jeffrey FergusonSep 1, 2025
Why is my Market Forge Industries Laboratory Equipment heating element cutting out too soon?
- J
  Jacob BrownSep 1, 2025
  If the heating element cuts out before reaching 15 lbs of pressure, the pressure might be cutting off too soon at the temperature control. Readjust the range of operation and calibration of the temperature control.

Market Forge Industries STM-E Specifications

General

Type	Steam Sterilizer
Chamber Material	Stainless Steel
Material	Stainless Steel
Heating Source	Electric
Control Type	Electronic
Pressure Rating	Varies by model
Agitator	No

Related product manuals

Market Forge Industries STM-EX

15 pages

Market Forge Industries STM-EL

15 pages

Market Forge Industries STM-E - User Manual

Table of Contents

Questions and Answers

Market Forge Industries STM-E Specifications

Related product manuals