31
SINTER-2 USER GUIDE
REPLACING GAS SUPPLY FILTERS
Note: Due to the constrained nature of the fittings, the filters can be somewhat difficult to thread.
Always change both supply lters at once.
1.
2.
3.
4.
5.
6.
Note: Failure to complete steps 1-2 and reduce mix gas pressure before completing the
following steps may lead to O-ring damage.
7.
Note: Gas will begin to flow when you unscrew the top thumbscrews. This behavior is to be
expected.
8.
9.
10.
To Next Page
Loading...
