MARKLIFE P50 - Marklife APP Features; Trouble Shooting Guide

MARKLIFE APP FEATURES

20
Label content editing
Marklife APP supports bold font, italic, line spacing, and word
spacing adjustment. Even support adding pictures of text type or
  sketch type, borders, stickers, dates, QR codes generated by the
label maker, graffiti, and consecutive serial numbers.
This printer supports photos & sketches printing.
You can use the excel importing function after login in.
Cloud Template
You can also find a template from“cloud template” with the same size
and the same appearance as the label you’re using to create a label.
If you choose a template that does not match the size and the
appearance of the label you are using, it will result in a failed print.
TROUBLE SHOOTING GUIDE

21
If your problem is not found in the table below, you can shut down
and reboot to try again.
Any questions, welcome to send an email to us, we will be happy to
serve you!
Category
Abnormal
light
Display
Bluetooth
Label
Calibration
Item NO. Question Answer (Possible causes and solutions)
Why does it
show a red light?
a. Paper shortage: Replace the label ;
b. Overheat: Turn off the printer and wait for it to
cool down before using it again.
Low Power:Charge the printer
Debugging mode has been entered: Shut down
and then restart.
A.Please connect it from the“ Marklife” App, not
from the Phone Bluetooth section.
B.Cell phone Bluetooth is not open, open the
Bluetooth.
C.Printer Bluetooth failure when the red light
flashes rapidly, refer to item 2.
D. Printer Bluetooth is occupied by another cell
phones.
E.The Android mobile APP needs to obtain
location permission before it can search for
nearby printers.
a.Turn on the label maker, press the 0n/0ff button
twice in quick succession, the a label maker will
come out with a label for the label Calibration.
b.The calibration is OK if the end of the label is right
next to the label exit, if only part of the label comes
out, please press the button again for re-calibration.
Why is the
red light
flashing?
Why does it
show an orange
light?
Why does the
printer connect
fail
How to
do Label
Calibration
1
2
3
4
5