marklin 70421 User Manual

9
CV Meaning Values
39
PoM*
Slow movement 0 (0)
Medium fast movement 1
Fast movement 2
Medium fast movement
with bouncing
3
Fast movement with
bouncing
4
Medium fast movement
with bouncing of Arm 1
5 only with 70411 /
70412
Medium fast movement
with bouncing of Arm 2
6 only with 70411 /
70412
40
PoM*
Meaning Lighting 0 - 15 (15) 0 light off
Dimming 0-15,
whereby 15 = 100%
brightness
41
PoM*
Center setting for Arm 1 0 - 255 Setting of the middle
position for the arm
on all signals
42
PoM*
Center setting for Arm 2 0 - 255 Only with 70411 /
70412 Setting of the
middle position for the
2nd arm
*PoMprogrammingcanbedoneonthemaintrackaslongasit
issupportedbythecontroldevice.
Setting and Calculating Addresses Greater than 255 (DCC):
Example:Address1044->1044:256=4.078125.Thevaluebefore
thedecimalpoint(4)isenteredinCV9.Thevalueafterthe
decimalpoint(0.078125)ismultipliedby2560.078125x256=20.
Thecalculatedvalueof20mustbeenteredinCV1.
Operation with mfx
mfxregistrationcanbedonewithMMorDCC.Themodeofope-
rationthathasbeensetbymeansofDipSwitch10iscritical.
The mfx registration is initiated with the 60213/60214/60215 CS2
in
> and with the 60216/60226 CS3 in the solenoid item
configuration by means of
>“searchformfxitem“.
Note about mfx registration with the CS2:
Selection possibility „Automatically assign solenoid item“ at
„Setup“>
>„Track“.
If the check mark there is checked, the mfx registration is done
attherstopenaddressintheCS2.Ifthecheckmarkisnot
checked, the mfx registration is done at the address actually
programmedonthedecoder.

marklin 70421 Specifications

General

Brand	marklin
Model	70421
Category	Toy
Language	English