◢MR6100 Serial UHF reader user manual（Ver 1.0）◣
Address：
Floor 3/5, Block D,Changyuan New Material Port, No 2 Central 1st Hi-tech Av., Nanshan Shenzhen, P.
R.C. Post：518057
Phone：0755-2654 6392 FAX：0755-2655 3743
E-mail：technical@marktrace.com Website：www.marktrace.com
6.1.2 Multi Tag Read & Write
1、On Gen2 EPC Multi Tag interface‟s Multi Tag Read menu for the Multi tag
read, Multi tag reader is read tag‟s RESERVE Membank, EPC Membank, TID
Membank & USER Membank at the same time. The steps are: 1) select the
reading Membanks, 2) select the start reading address and the reading word
count (EPC tag‟s unit is word), and then click „Read‟ ICON to start the Multi-tag
reading. Take below image for the reference.
2、Click „Stop‟ ICON to stop Multi-tag reading, at the bottom of the demo
software interface display the tag number, and the reading duration time.
3、On Gen2 EPC Multi Tag interface‟s Multi Tag Write menu for Multi tag
encoding. Multi-Tag Write is to encode the tag‟s Reserve Membank, EPC
To Next Page
Loading...