Marport M4 - Connecting the Hydrophone to the Receiver

M4 - Mx computer System | V2 | Installation
Connecting the Hydrophone to the Receiver
You need to connect the hydrophone to the receiver to be able to display sensor data received by the
hydrophones.
Procedure
• Connect the extension cable of the junction box to a hydrophone input on the receiver:
• Using an NMEA converter junction box (P/N: NC-2-TEMP), connect to the hydrophone
input 1 or 2 at the back of the receiver to be able to receive water temperature from Marport
hydrophones.
Note: Hydrophone inputs 1 and 2 allow to receive temperature from an NMEA
connection, so you need an NMEA converter junction box. If you connect to other
hydrophone inputs or have no NMEA converter, you will not have temperature data
from Marport hydrophones.
| 20