Service Manual - DVH 09/12/18/24 SF Series
Service Manual - DVH 09/12/18/24 SF Series
37
9.3.4 Fan speed has been out of control diagnosis and solution (E3)
Error Code
Malfunction conditions
When indoor fan speed keeps too low (300RPM) for certain time,
the unit will stop and the LED will display the failure.
Possible causes
● Wiring error
● Fan assembly faulty
● Fan motor faulty
● PCB faulty
Troubleshooting:
Power off, then restart the
unit 2 minutes later
Shut off the power supply,
Rotate the fan by hand.
The unit operates normally.
Find the cause and repair.
Check the wiring of fan
motor
No
Yes
No
Correct the connections.
No
NoReplace the fan motor
Yes
Yes
Measure the voltage for the
fan motor from the main
PCB refer to the
Appendix 1
Yes
Replace the main PCBNo
To Next Page
Loading...
